Stoneology Densifier

A High performance chemical treatment that hardens, strengthens, stabilizes, protects, increases mass, density and useful life of concrete and is NONTOXIC.

• Reduces porosity - seals contaminants
• Increases surface hardness
• Increases mass and density
• Reduces chloride penetration
• Retards scaling of high-strength concrete
• Produces a sheen on dense steel troweled floors
• Easy to apply
• Nontoxic

Application Instructions:

1. Surface must be thoroughly cleaned of foreign material such as grease and coatings.
2. Allow the surface to to be completely dry for 10 to 12 hours before application of densifier.
3. Protect decorative fronts, glass, painted surfaces and aluminum from contact with densifier as it may stain these surfaces.
4. Apply by pouring and spreading with a broom or by spraying. Saturate the surface and keep it wet until the densifier becomes slippery.
5. Squeegee or vacuum surface to remove excess and allow surface to dry.
6. Clean equipment with soap and water promptly after use. Do not store densifier in aluminum containers or spraying equipment.
7. Dispose of properly per Federal, State or local Environmental regulations.